Aquacraft Revolt 30 Bedienungsanleitung

™aquacraftmodels.com

10SHAFT AND MOTOR MAINTENANCE:After each day of operation we feel it’s best to remove the motor and fl ush it out with a moisture displacer and re-oil

11After each fi ve or so runs and or after a day of running it’s a good idea to relubricate the drive cable. Here are the tools and supplies you need t

RACING:Your Revolt was designed to fi t into boat IMPBA and NAMBA P class racing. What you will fi nd is power systems designed for this boat and others

2INTRODUCTION AND DESCRIPTION CHANGES:Thank you for purchasing the AquaCraft Revolt. We at AquaCraft want the time you spend with your boat to be safe

3SAFETY PRECUATIONS:Never, ever attempt to swim after a stalled RC boat. DO NOT get in the water for any reason to retrieve your boat. Your Revolt has

4RECEIVER READY (Rx-R) ASSEMBLY:Here are a few great radios to choose from for your receiver ready (Rx-R) Revolt.Tactic TX240 (TACJ0245): The TX240 ra

5START UP AND OPERATION:IMPORTANT:Your Revolt is a true racing boat. In our quest to provide you with the very best performance, we feel it is importa

6TROUBLESHOOTING:No signal between the transmitter andthe boat (Performance 2.4GHz version):Check to make sure the transmitter is bound to the receive

72. Solder the wire across the two solder tabs, creating a bridge between the two tabs. Use your side cutters to remove the excess wire.3. Cut the shr

8OPTION 3 (The most advanced but allows the best contact between the controller and battery pack):Tools and supplies needed are:5.5mm Bullet connecto

9We are going to update the battery pack the same way BUT...we are going to cut and change one connector at a time starting with the red (positive wir