Aquacraft Air Force Bedienungsanleitung

Before BuildingWe want the assembly and operation of this airboat to be a success so BEFORE removing any parts from the parts bags,please read this ma

❏ 3. Remove the fuel line stopper from the fill line and insertthe filler nozzle (not included).❏ 4. Fill the tank almost to the top (viewable from th

❏ 10. Remove the glow starter after 10-15 seconds.IMPORTANT NOTE: Never place your finger over thecarburetor intake when applying the starter. S

Glow PlugThe glow plug is an item that will wear out and needreplacement from time to time. It is a good idea to remove theglow plug before

To order replacement parts for the AquaCraft Air Force, use theorder numbers in the Replacement Parts List that follows.Replacement parts ar

14ENGINE TROUBLESHOOTINGThe engine startsDoes the engineturn over easily?Does it runcontinuously?Is fuel getting tothe engine?Check for clogging inthe

15ENGINE MOUNTING TEMPLATE

INTRODUCTION ...2SAFETY PRECAUTIONS...2H

Repair service is available anytime.After the 90-day warranty, you can still have your Air Forcerepaired for a small charge by the experts at

Note: If you have the prebuilt version, proceed to page 6.Engine and Propeller Installation❏ 1. Looking down at the top (deck) of the hull, remove the

backplate. If you see a gap, check to make sure that the propis installed correctly.Installation of Batteries❏ 1. Remove the five hatch screws

❏ .40 – .46 size engine.❏ 2-channel radio system w/ two servos❏ 1. Remove your engine’s upper right backplate screw asshown, to install the m

❏ 4. Test fit the engine and engine mount to determine theproper width of the supports. Then tighten the 4 x 20mm screws.❏ 5. Cut out the en

❏ 11. Screw the clevis onto the throttle pushrod and attachit to the inside hole of the throttle lever.❏ 12. Finish the throttle cable installation by

❏ 1. If your radio system’s on/off switch has a hole throughthe side, attach the exterior switch hardware as shown. Thebattery box and receiver are h